[GreenKeys] Dangling Part

[Mike Arrington]

Yes, the function pawl springs are in the front.  I've been staring at the
back for too long and forgot that's where they are.


On Wed, Jul 24, 2019 at 11:08 AM Ken Wiebe <me at networkguy.com> wrote:

> Yes, you're right, Wayne - when I went home last night and looked at it
> again I realized that area is more accessible from the front than I thought.
>
> My hope/plan is that I can fix this minor issue then toy around with the
> 33 a little.  I have an RS-232 adapter for it.  Longer-term I plan to do
> some restorative work on it.  Mostly cleaning, although it doesn't seem to
> be too bad.
>
> So before I plug it in I'm going to replace the hammer.  I already turned
> the motor over by hand and other than the signal bell pawl issue I don't
> see any problems.
>
> Do you (or anyone) have any other "must-do" advice for first-time start-up
> after sitting for years?
>
> Are there some super critical lube points I should check to make sure
> they're not dry, for example?
>
>
> On Wed, Jul 24, 2019, at 08:49, WAYNE wrote:
>
> Mike and Ken,
>
>
> I hate to disagree but you should be able to fix this from the top, front
> and back.  Not fully sure of my take on this because I cant quite see the
> exact parts in the pic.  but if you want to remove the printer here is my
> procedure.
>
>
> Mikes brief description is good as well.
>
>
> 73,
>
>
> Wayne
>
> KB1FDW
>
> *Attachments:*
>
>    - 32 and 33 Printer Removal and Re-install.odt
>
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://mailman.qth.net/pipermail/greenkeys/attachments/20190724/486f53fc/attachment.html>