[GreenKeys] Dangling Part

[Ken Wiebe]

Yes, you're right, Wayne - when I went home last night and looked at it again I realized that area is more accessible from the front than I thought.

My hope/plan is that I can fix this minor issue then toy around with the 33 a little. I have an RS-232 adapter for it. Longer-term I plan to do some restorative work on it. Mostly cleaning, although it doesn't seem to be too bad.

So before I plug it in I'm going to replace the hammer. I already turned the motor over by hand and other than the signal bell pawl issue I don't see any problems.

Do you (or anyone) have any other "must-do" advice for first-time start-up after sitting for years?

Are there some super critical lube points I should check to make sure they're not dry, for example?


On Wed, Jul 24, 2019, at 08:49, WAYNE wrote:
> Mike and Ken,

> 

> I hate to disagree but you should be able to fix this from the top, front and back. Not fully sure of my take on this because I cant quite see the exact parts in the pic. but if you want to remove the printer here is my procedure. 

> 

> Mikes brief description is good as well.

> 

> 73,

> 

> Wayne

> KB1FDW

> 
> *Attachments:*
>  * 32 and 33 Printer Removal and Re-install.odt
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://mailman.qth.net/pipermail/greenkeys/attachments/20190724/80704b5d/attachment.html>