[GreenKeys] Perforator success...

[E.]

Hey all,

Always good to take a few days off to reset the brain.  Did some troubleshooting today after pondering over the past few days what could be wrong and discovered why the perforator wasn’t working… the 2k ohm resister for the base tying unit was the whole cause!  Was playing it safe (before) when hooking up the power supply to the DC lines at the base… didn’t think the 2k resister would have all that much effect on the power supply to the perforator (never was good at algebra), but it did.  Removed the resistor from the DC line and boom, it works again!  Was totally confused why things weren’t working when every line and circuit checked out on the ohm meter… duh!  Anyways, working again - back to concentrating on getting the rest of it back together (95% of the way there)…

Cheers!

Sincerely,
Eric :)
-.- ----- .--- .. .-


-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://mailman.qth.net/pipermail/greenkeys/attachments/20180224/0b3692f8/attachment.html>
-------------- next part --------------
A non-text attachment was scrubbed...
Name: IMG_20180224_0001.jpg
Type: image/jpeg
Size: 69838 bytes
Desc: not available
URL: <http://mailman.qth.net/pipermail/greenkeys/attachments/20180224/0b3692f8/attachment.jpg>