[GreenKeys] M15 How to disable unshift-on-space?

[drlegendre .]

Took another look. It is an eccentric, and allows adjustment between the
lever and the projection on the other bar. Thing is, at the tightest
setting, I can't get closer than 0.020", which is kinda far from 0.006".

Would that actually be enough to do it? I noticed that when the cutout
lever is in the "allow" position, the bar it restrains only moves a few
thou.. about the same as when it's in the "disallow" position.

Is it really that tight of a setting? And if yes, why can't I get it set
properly? I inspected the parts, and didn't see any obvious wear at the
point where they contact.

On Fri, Sep 18, 2015 at 1:40 PM, Jim Haynes <jhhaynes at earthlink.net> wrote:

>
> Now after looking at the manual I see that the screw for the USOS
> cutout lever is an eccentric screw, so maybe you need to position it
> to give the space function bar less freedom to move.  It says a
> clearance of .006 between the tail of the function bar and the cutout
> lever.
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://mailman.qth.net/pipermail/greenkeys/attachments/20150918/d612afcc/attachment.html>