[GreenKeys] OT: Cog Belts/Timing Belt Source

[Cory Heisterkamp]

Thanks for the suggestions guys! I'll have to check a few of these out. I
ran the gamut through Grainger but came up empty handed. Unfortunately, all
I have is an IBM number for the one, nothing on the other, and both are
cracked in half. The rubber's not in the best of shape but I think I can
get good enough measurements if I'm careful. I'll give it a shot-  Cory


On Mon, Oct 7, 2013 at 4:01 PM, Ron Kolarik <rkolarik at neb.rr.com> wrote:

> **
> Try Small Parts Inc., they are now part of Amazon Supply
> http://www.amazonsupply.com/
> Or try the shops that supply the hobby robotics bunch.
>
> Ron
> K0IDT
>
> ----- Original Message -----
> *From:* Cory Heisterkamp <coryheisterkamp at gmail.com>
> *To:* greenkeys <greenkeys at mailman.qth.net>
> *Sent:* Monday, October 07, 2013 12:42 PM
> *Subject:* [GreenKeys] OT: Cog Belts/Timing Belt Source
>
>  Hope this doesn't stray too far off topic, but I was wondering if any
> members had a recommended source for the cog belts (sometimes referred to
> as timing belts) that are used on TTY (and similar paper tape/punch card)
> machines. In this case I'm working on an IBM 083 card sorter and noticed
> the similarity to some of my teletype equipment.
>
> Thanks-
> Cory Heisterkamp
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://mailman.qth.net/pipermail/greenkeys/attachments/20131007/1783d1a0/attachment.html>