[GreenKeys] ASR 33

[Teletypeparts]

Cory,

Go to a fabric store and get a piece of 1/2 inch foam rubber.  I have only been able to find it in green.  Cut to 10 x 11 inches and nip out a 1 inch square on each corner on the long end.  That will install toward the rear just between the rubber feet.  You have to remove the printer and clean out the old mat.  If you have never removed a printer you probably are better off to leave it as is.  

Wayne
KB1FDW




-----Original Message-----
From: Cory Heisterkamp <coryheisterkamp at gmail.com>
To: Teletypeparts <teletypeparts at aol.com>
Cc: douglas-w-jones <douglas-w-jones at uiowa.edu>; greenkeys <greenkeys at mailman.qth.net>
Sent: Tue, Nov 26, 2013 3:44 pm
Subject: Re: [GreenKeys] ASR 33



While on the subject of ASR33 R&R, I've got a very clean tabletop model 33 (should there be a stand?0, practically brand new and with very little use, but I noticed the sound deadening/oil absorbing pad in the bottom deteriorates upon contact with my finger. Any advice on replacement material or sources for this? Everything else on the unit is clean as a pin. Either way I've got to get the old one out of there lest it crumble and gum up the works.  


Thanks,
Cory





-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://mailman.qth.net/pipermail/greenkeys/attachments/20131126/44f36777/attachment.html>