[GreenKeys] ASR33 print hammer pad

[Larry Tighe]

I went to the "home store" and bought 1 fot of, if I remember, 3/4 in. clear 
tubing.  Cut off about 3/4 in. length or maybe 1 in. of the tubing and slip 
it over the "hammar".  This is an excellent replacement for the mushy part. 
It works perfectly.  Not sure of the diameter of that clear tubing....but, 
mess around, you'll figure it out.

lar
----- Original Message ----- 
From: "B M" <iamvirtual at gmail.com>
To: <greenkeys at mailman.qth.net>
Sent: Monday, September 07, 2009 7:08 PM
Subject: [GreenKeys] ASR33 print hammer pad


> Hi,
>
> The rubber pad for the print hammer is mushy on my recently acquired
> ASR33 teletype.  What is the best way to replace this rubber pad?  Are
> these rubber pads available?  So far, the printhead looks uninjured.
>
> Thanks!
>
> --barrym
> ______________________________________________________________
> GreenKeys mailing list
> Home: http://mailman.qth.net/mailman/listinfo/greenkeys
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:GreenKeys at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html