[GreenKeys] source for new 1" paper tape?

[Don Robert House]

KEN,

YOUR ADVICE SPEAKS WITH A HIGH LEVEL OF LOGIC.

THANK YOU!!

DON



On 11 Jan 2009, at 8:15 PM, Ken Schwieker wrote:

Somehow that method seem fraught with finger loss written all over
it. Wouldn't want you not to be able to count to ten anymore Don. At
the place I worked (Ampex/Quantegy Magnetic Tape Division) we had a
sample slitter that used single edge razor blades. Side by side with
a spacer between them equal to the desired width mounted at a 45
degrees angle so they sliced better. It wasn't paper tape and it
wasn't the length of a paper roll but with new blades each time it
did a pretty good job. Other possibility is that I believe I have
some slitter blades that I could send someone a set if they had the
expertise to make something to pull the tape and turn the blades. The
blades are round about 3 to 4" dia with a hole in the center and it
takes two mounted side by side against each other for each cut.  How
wide are the rolls that you have?  If I didn't have so much on my
plate I would take a stab at it.
Later,
Ken S



> I have a band saw and lots of rolls but I am not sure if the opening
> is large enough.  I promise to give it a try.
>
> Thanks !
> Don

_______________________________________________
GreenKeys mailing list
GreenKeys at mailman.qth.net
http://mailman.qth.net/mailman/listinfo/greenkeys