[GreenKeys] source for new 1" paper tape?

[Ken Schwieker]

Somehow that method seem fraught with finger loss written all over 
it. Wouldn't want you not to be able to count to ten anymore Don. At 
the place I worked (Ampex/Quantegy Magnetic Tape Division) we had a 
sample slitter that used single edge razor blades. Side by side with 
a spacer between them equal to the desired width mounted at a 45 
degrees angle so they sliced better. It wasn't paper tape and it 
wasn't the length of a paper roll but with new blades each time it 
did a pretty good job. Other possibility is that I believe I have 
some slitter blades that I could send someone a set if they had the 
expertise to make something to pull the tape and turn the blades. The 
blades are round about 3 to 4" dia with a hole in the center and it 
takes two mounted side by side against each other for each cut.  How 
wide are the rolls that you have?  If I didn't have so much on my 
plate I would take a stab at it.
Later,
Ken S



 >I have a band saw and lots of rolls but I am not sure if the opening
 >is large enough.  I promise to give it a try.
 >
 >Thanks !
 >Don