[GPS_Standard] GPS_Standard Digest, Vol 27, Issue 1

[Roberto Barrios]

Hi Bob,

Let see what Bert has to say, but I believe that current firmware only
allows to do it via serial comm.

You could prepare a little PIC that sends the alarm-off message to the
controller with the touch of a button, and keep everything inside your
enclosure.

73 de Roberto, EB4EQA
Madrid

----------------------------------------------------------------------

Message: 1
Date: Sun, 15 Mar 2009 16:37:38 -0800
From: "k7hbg @dslextreme.com" <k7hbg at dslextreme.com>
Subject: [GPS_Standard] status alarm
To: Berts Reflector <gps_standard at mailman.qth.net>
Message-ID:
	<e3f0db810903151737o761f0deay9395590974f18354 at mail.gmail.com>
Content-Type: text/plain; charset=ISO-8859-1

Thanks Bert!;
 That whole transaction happened so fast I couldn't keep up with it.

My "ZAZ Frequency standard" usually operates as stand alone without a PC
attached.

 The front panel has the "output enabled" and "FLL status" LEDs mounted on
it. After
start up and lock, the red error indication remains on (blinking) even
though the
start up sequence and lock was successful. Is there anyway to reset this LED
indication
after the fault no longer exists without a PC connection?

73s Bob K7HBG


------------------------------

_______________________________________________
GPS_Standard mailing list
GPS_Standard at mailman.qth.net
http://mailman.qth.net/mailman/listinfo/gps_standard


End of GPS_Standard Digest, Vol 27, Issue 1
*******************************************