[GCARC] Concrete estimates for club site

[Vinnie Sallustio]

Most towns require a 4" base of 3/4" gray stone. Leveled, of course. I have had my shed for 14 years on this, and it is still in fantastic shape. The floor joists and floor boards are pressure treated. Basically, you lay out and level 4x4s on the perimeter of the shed (about 6" bigger around than the shed itself) The center of the 4x4s is then filled and skreeted with gray stone. Drains better and less rot than wood on concrete.

Get Outlook for Android<https://aka.ms/ghei36>

________________________________
From: gcarc-bounces at mailman.qth.net <gcarc-bounces at mailman.qth.net> on behalf of Harry Elwell <elwellharry at gmail.com>
Sent: Saturday, June 10, 2017 12:10:36 PM
To: gcarc at mailman.qth.net
Subject: [GCARC] Concrete estimates for club site

When Lee N2LAM approached me with an idea concerning the use of a poured
concrete pad for the shed as opposed to the current dry-stack block
foundation that is currently supporting the shed, we discussed the
possibility of purchasing the concrete from a local ready-mix plant and
enlisting the help of volunteers to prepare the site and finish the
concrete.
Lee suggested reaching out to some outside contractors for estimates.
Somewhere along the way, we got our wires crossed. Lee was under the
impression that we were talking about hiring a contractor for the entire
job.
I did not discover the mix-up until I heard Lee address the members at the
club meeting which I was listing to via Periscope from the hospital.
In the original discussion with Lee, I told him that I was in favor of
exploring the possibility of a small poured pad to replace the current
foundation provided we could do it for a reasonable cost.
There are several options available when planning small projects requiring
concrete. Obviously, as mentioned, ready-mix is fast and easy; however,
give the small size of the project (approximately 2 yards allowing for
waste), we would realize some penalties with regard to cost due to "short
load" fees.
Another option would be bagged pre-mix concrete and a rental mixer. This
would likely result in a lower cost at the expense of more labor and time.
Prior to being contacted by Lee, I had never considered a pad for the shed,
nor had we discussed this at any club meetings. Since Lee has already
presented the idea of the pad at the last meeting, I would welcome any
comments on his proposed project to use a pad for the shed, provided the
project includes volunteer labor from our members and that it can be
accomplished for a reasonable cost.
Best regards,
Harry
K2ATX
______________________________________________________________
GCARC mailing list
Home: http://mailman.qth.net/mailman/listinfo/gcarc
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:GCARC at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html