[FADCA] Re: Digital Voice over our links?

[russ]

Good notes. Thanks, Chuck.

Russ
----- Original Message -----
From: <wchast@utilpart.com>
To: <fadca@mailman.qth.net>
Sent: Friday, October 18, 2002 12:17 AM
Subject: RE: [FADCA] Re: Digital Voice over our links?


> After I made my previous comments to you about
> digital voice, I fired up SpeakFreely on my two
> company machines where I am testing our software
> running over AX.25 UI packets. I am using a couple
> of Tiny 2's with 2k4 baud modems in them. They are
> talking over a couple of FRS radios (I did that so
> I could show our people at work that our software
> can go almost anywhere we can send data).
>
> Anyhow I fired up SpeakFreely and selected the
> LPC-10 compression using the SpeakFreely protocol,
> that said I then established a link over my 2k4
> path via the FRS radios and indeed it was a bit
> jerky but quite understandable. I will be setting
> up 9k6 over the next few days and will give you
> a report on the difference, but the test shows
> that we can move audio between points using our
> network, perhaps in this case you might send
> the voice and larger blocks of data, I am going
> to look deep into SpeakFreely and see if there is
> a way to cause it to block voice data into larger
> blocks so you do not get as many breaks between
> sylables.
>
> Pull it down and give it a try you might well
> be suprised at what you can do.
>
>
>
>
>
> *****************************************************************
> This e-mail and any files transmitted with it are confidential and are
> intended solely for the use of the individual or entity to whom it is
> addressed. If you have received this transmission in error, please notify
> the sender immediately and destroy any hard copies you may have printed
and
> remove all copies of the e-mail from your hard drive. Opinions,
conclusions
> and other information in this message that do not relate to the official
> business of Utility Partners, Inc shall be understood as neither given nor
> endorsed by it.
>
> Visit us on the web at http://www.utilpart.com
> *****************************************************************
>
>
> _______________________________________________
> FADCA mailing list
> FADCA@mailman.qth.net
> http://mailman.qth.net/mailman/listinfo/fadca
>