[ETO_Alpha] Help Needed: Alpha 77dx/sx cabinet

[jbattin]

If the pieces have surface problems ... I did a very expensive, but
effective job on my amp. I took the pieces to a machine shop and had them
mill off the anodization. Then I had them re-anodized.
I have two pieces left over from years gone by...A new lower left piece, and
a used beat-up lower right.
John K9DX
----- Original Message -----
From: "James C. Garland" <4cx250b@muohio.edu>
To: <eto_alpha@mailman.qth.net>
Sent: Saturday, May 04, 2002 9:32 AM
Subject: [ETO_Alpha] Help Needed: Alpha 77dx/sx cabinet


> Hi Gang,
> I'm in the final stages of restoring an Alpha 77sx, and would like to find
> some of the extruded aluminm trim pieces that frame the cabinet. The
> cabinet was manufactured by Buckeye Shapeform, and came in various sizes.
> However, the line was discontinued several years ago and no trim pieces
are
> avaialble from the manufacturer. Anybody have suggestions on where I could
> find some?
> Tnx and 73,
> Jim Garland W8ZR
>
>
> ***********************************************
> Check out W8ZR's new homebrew legal-limit autotuner:
www.w8zr.net/eztuner/
> ***********************************************
>
> _______________________________________________
> ETO_Alpha mailing list
> ETO_Alpha@mailman.qth.net
> http://mailman.qth.net/mailman/listinfo/eto_alpha
>