[Elecraft] Sticky low TX power level after ATU activation?

Ray WA6VAB wa6vab at gmail.com
Tue Oct 27 10:52:21 EDT 2026


Mike.. are you having Wet weather?  Rain can affect the Z of an open Wire
System.
WA6VAB Ray K3


On Tue, Oct 27, 2026, 5:41 AM Michael Carter via Elecraft <
elecraft at mailman.qth.net> wrote:

> [this post duplicates my post of yesterday to the Elecraft-K3 at groups.io
> forum; thought I would try here as well for those who use the official
> Elecraft forum]
>
> In this past weekend's CQWW SSB contest, I observed a phenomenon that I
> had occasionally encountered in CW contests.  I have a K3 with the KPA3A PA
> module and the original KAT3 ATU installed.  I use a single 66 foot
> center-fed doublet (450 ohm window line) on bands from 80 through 10 meters
> to a Johnson Matchbox as the first impedance transformer, then use the
> internal ATU to make the TX happy.  I have previously found Matchbox
> settings that yield moderately low SWR on each band, certainly well within
> the KAT3 matching capability.
>
> What I noticed this weekend is that when I tuned across the phone segments
> of each band, I had to activate the ATU to remove the 'HIGH SWR' warning
> that popped up from time, which I did.  However, on the next transmission
> after that ATU activation, the TX output power was very low.  On a whim, I
> did one of those ATU activations, then rotated the POWER control knob a bit
> down and back up.  The TX power was again at its high setpoint (~ 100
> watts).
> I think the sticky low TX power after ATU activation was less noticeable
> in CW contests because the tuning range is more limited, typically the
> lower 60 kHz of each band except on 10 meters during a big opening.  The
> extent of the phone segments meant more SWR variation across the segment
> and the need for more ATU activations.
>
> Is this a known behavior of the TX power control?  I know it automatically
> ratchets down the TX power when the ATU is activated, but it seemed that
> the TX power 'stuck' at the low ATU tuning level until the POWER control
> knob was rotated.
>
> Thanks for any insights!
>
> 73,
> Mike, K8CN
>
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to wa6vab at gmail.com
>


More information about the Elecraft mailing list