[Elecraft] Sticky low TX power level after ATU activation?

Michael Carter Mike.Carter at unh.edu
Tue Oct 27 08:41:12 EDT 2026


[this post duplicates my post of yesterday to the Elecraft-K3 at groups.io forum; thought I would try here as well for those who use the official Elecraft forum]

In this past weekend's CQWW SSB contest, I observed a phenomenon that I had occasionally encountered in CW contests.  I have a K3 with the KPA3A PA module and the original KAT3 ATU installed.  I use a single 66 foot center-fed doublet (450 ohm window line) on bands from 80 through 10 meters to a Johnson Matchbox as the first impedance transformer, then use the internal ATU to make the TX happy.  I have previously found Matchbox settings that yield moderately low SWR on each band, certainly well within the KAT3 matching capability.

What I noticed this weekend is that when I tuned across the phone segments of each band, I had to activate the ATU to remove the 'HIGH SWR' warning that popped up from time, which I did.  However, on the next transmission after that ATU activation, the TX output power was very low.  On a whim, I did one of those ATU activations, then rotated the POWER control knob a bit down and back up.  The TX power was again at its high setpoint (~ 100 watts).
I think the sticky low TX power after ATU activation was less noticeable in CW contests because the tuning range is more limited, typically the lower 60 kHz of each band except on 10 meters during a big opening.  The extent of the phone segments meant more SWR variation across the segment and the need for more ATU activations.

Is this a known behavior of the TX power control?  I know it automatically ratchets down the TX power when the ATU is activated, but it seemed that the TX power 'stuck' at the low ATU tuning level until the POWER control knob was rotated.

Thanks for any insights!

73,
Mike, K8CN



More information about the Elecraft mailing list