[Elecraft] k2 on6cn

Andrew Lenton a at lenton.org
Sun Oct 18 13:55:26 EDT 2026


Hi Carlos, 
  
  
  
  
  I think the next step is to break the loop, lift R30 and inject an 
external DC from a variable power supply. 
  
  
  
  
  6V is the 4MHz point so the LO should be 8.915MHz. 
  
  
  
  
  Assuming I have my arithmetic correct. 
  
  
  
  
  IF is 4.195 MHz 
  
  
  
  
  Start at 80M  the LO covers 6 to 24 MHZ, so on 80M the LO is high 3.5 + 
4.915 MHz to 4 MHz + 4.915MHz. 
  
  
  
  
  If this checks out then the LO is fine. 
  
  
  
  
  I am sure I can come up with a spread sheet for al the bands., 
  
  
  
  
  Not sure if 40M LO  is above or below but I can check. 
  
  
  
  
  I am only on my phone not at my PC with everyone front of me. 
  
  
  
  
  If you do not have a control power supply, you could use a pot and the on 
boards DVM, but gets messy. 
  
  
  
  
  Due to you lack of test equipment it is going to be hard to get you to 
the fault! 
  
  
  
  
  KR 
  
  
  
  
  Andrew  
  
  
  
  
  If you really get stuck, post to me for repair, there will be no charge. 
I have all the bits in stock. 
  
  
  
  
  
  
  
  
  
  
  
  
  
  
  
  
  
  
  
  
  
  
  4.936 MHz 
  
  
  
  
  
  
  
  
  
  
  


  
  
Hi Carlos, 
  
  
  
  
  
  
  
  
  
Thanks for checking the frequency at TP1, the output of the VFO buffer.  
Since the frequency doesn't change when you move from band to band, that 
indicates that the PLL is not locking at all.  That would explain the phase 
detector amplifier going to one of
  its rails. 
  
  
  
  
  
  
  
  
  
I am a bit confused about the relays.  I thought you previously wrote that 
you could feel relays K13, K14, and K15 changing state as you cycled 
through the bands?  In your most recent post, you said you can't hear any 
relays changing as you change bands.  I'll
  have to review the K2 manual again because I don't recall if using the 
internal frequency counter disables some of the other functions of the MCU. 
  
  
  
  
  
  
  
  
  
  
Since the VFO frequency is stuck at some value, what is that value?   
  
  
  
  
  
  
  
  
  
Thanks for your patience as we navigate through this difficulty. 
  
  
  
  
  
  
  
  
  
73, 
  
  
  
Mike, K8CN


More information about the Elecraft mailing list