[Elecraft] k2 on6cn

Michael Carter Mike.Carter at unh.edu
Sat Oct 17 21:15:03 EDT 2026


Hello again, Carlos,

You may need to move from band to band first, then activate the FCTR from the Calibration menu.  When the CAL FCTR is enabled, the BAND+ and BAND- buttons operate differently than when the CAL FCTR is disabled.

Your earlier post when you tested the VFO output using the internal frequency counter indicated that there is VFO output in the proper range.  That is encouraging.

If you put the K2 into transmit mode on any frequency using a dummy load, can you hear the signal on another receiver?

Thanks, and 73,
Mike, K8CN


More information about the Elecraft mailing list