[Elecraft] k2 on6cn

Andrew Lenton a at lenton.org
Sun Oct 18 11:18:08 EDT 2026


Hi Level cold be an issue, as the frequency counter is very sensitive, 
  
  
  
  
  I scope would help here. 
  
  
  
  
  Hardware IC's really go bad, but not impossible. 
  
  
  
  
  Decoupling caps poor joints is far more likely. 
  
  
  
  
  
  
  
  
  
  
  
  
  
  KR 
  
  
  
  
  Andrew 
  
  
  
  
  
  
  
  
  
  
  


  
  
Hi Carlos, 
  
  
  
  
  
  
  
  
  
Depending on your choice of email client, there may be a couple ways to 
keep your responses in the same thread.  I send a reply to one of your 
posts to <elecraft at mailman.qth.net> and copy your Subject line with an Re: 
ahead of it, for example, Re: [Elecraft]
  k2 on6cn . That keeps the conversation in a single thread. 
  
  
  
  
  
  
  
  
  
Now to the K2 issues:  
  
  
  
  
  
  
  
  
  
  
  You confirmed that the PLL reference oscillator is working and that the 
reference oscillator frequency can be varied by tuning the VFO knob.  This 
tells us that Q19 is working fine AND that the programmable voltage
  step generated by the DAC (U5) is controlled by the MCU via the AUXBUS. 
  
  
  
  You confirmed that you feel some vibration in the relays K13, K14, and 
K15 when you change the BAND setting on the front panel.  While this 
doesn't prove that the proper combinations of tuning capacitance are
  selected for the given band, at least we know the relays do respond to 
the driver signals from the I/O Controller. 
  
  
  
  
  
  
  
  
  
  
You mentioned a VCO test, which yielded a frequency of 9.149 Mhz.  Do you 
mean the VFO frequency at TP1 is that frequency?  The VFO frequency should 
change greatly as you step through the bands IF the loop doesn't have some 
other problem. 
  
  
  
  
  
  
  
  
  
Please measure the frequency at TP1 using the internal frequency counter as 
you change bands and report what frequencies you measure by band.  You 
don't need to change the VFO knob position  - just step through the bands 
with the BAND switch. 
  
  
  
  
  
  
  
  
  
If the loop is not changing the VFO frequency at TP1, that will be useful 
information.  If changing BANDs does change the VFO frequency, the pattern 
of frequencies will be useful. 
  
  
  
  
  
  
  
  
  
The loop could fail to lock if the VFO amplitude is too small, which would 
indicate a potential problem in the VFO ALC circuit.  Before investigating 
that issue, let us see what frequency measurements at TP1 tell us as BAND 
is changed. 
  
  
  
  
  
  
  
  
  
Thanks for your information, and 73, 
  
  
  
Mike, K8CN


More information about the Elecraft mailing list