[Elecraft] k2 on6cn
Michael Carter
Mike.Carter at unh.edu
Fri Oct 16 12:29:39 EDT 2026
Hi Carlos,
Depending on your choice of email client, there may be a couple ways to keep your responses in the same thread. I send a reply to one of your posts to <elecraft at mailman.qth.net> and copy your Subject line with an Re: ahead of it, for example, Re: [Elecraft] k2 on6cn . That keeps the conversation in a single thread.
Now to the K2 issues:
1.
You confirmed that the PLL reference oscillator is working and that the reference oscillator frequency can be varied by tuning the VFO knob. This tells us that Q19 is working fine AND that the programmable voltage step generated by the DAC (U5) is controlled by the MCU via the AUXBUS.
2.
You confirmed that you feel some vibration in the relays K13, K14, and K15 when you change the BAND setting on the front panel. While this doesn't prove that the proper combinations of tuning capacitance are selected for the given band, at least we know the relays do respond to the driver signals from the I/O Controller.
You mentioned a VCO test, which yielded a frequency of 9.149 Mhz. Do you mean the VFO frequency at TP1 is that frequency? The VFO frequency should change greatly as you step through the bands IF the loop doesn't have some other problem.
Please measure the frequency at TP1 using the internal frequency counter as you change bands and report what frequencies you measure by band. You don't need to change the VFO knob position - just step through the bands with the BAND switch.
If the loop is not changing the VFO frequency at TP1, that will be useful information. If changing BANDs does change the VFO frequency, the pattern of frequencies will be useful.
The loop could fail to lock if the VFO amplitude is too small, which would indicate a potential problem in the VFO ALC circuit. Before investigating that issue, let us see what frequency measurements at TP1 tell us as BAND is changed.
Thanks for your information, and 73,
Mike, K8CN
More information about the Elecraft
mailing list