[Elecraft] k2 vco voltage

Favre luc-favre at orange.fr
Tue Oct 13 04:03:17 EDT 2026


Hi,
I had a similar trouble with my K2 #7910. I changed Q19 without success.
To check the oscillator, do not rely on the internal frequency meter 
because the cable conected into P6 and TP3 may bring sufficient coupling 
to bring the oscillator into motion. Then check and reheat all solder 
joints. I had success !
Luc F6HJO

Le 13/10/2026 à 02:58, W3FPR via Elecraft a écrit :
> Carlos,
>
> The most probable cause is that Q19 is not operating properly.
> Is this a new build, or was it operating properly, then quit. That is 
> good troubleshooting information.
> If a new build, then it is possible that Q19 is not capable of 
> oscillation at the proper frequency.
> That is especially true if this is a kit tht has been "on the shelf" 
> for some time.
> There was a bad batch of FETs about 3 or 4 years ago, so if this is a 
> build of an older kit, get a new Q19 from Elecraft support and you 
> should be OK.
> In any case, get a new Q19 and see if things then go smoothly.
>
> 73,
> Don W3FPR
>
> On 10/10/2026 12:11 PM, carlos popelier via Elecraft wrote:
>> problem with k2 not receiving, 6v voltage not present or adjustable 
>> at r30
>> first only 80m en 40m working,getting worse all bands stopped, on r 30
>> voltage was + - 8v not adjustable, then 3,5v not adjustable, menus are
>> working, no error messages, audio is working, any ideas where to start
>> measuring.....
>>
>>
>> mvg carlos popelier
>> regards carlos popelier
>>
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to luc-favre at orange.fr 


More information about the Elecraft mailing list