[Elecraft] k2 vco voltage

W3FPR w3fpr111 at gmail.com
Mon Oct 12 20:58:51 EDT 2026


Carlos,

The most probable cause is that Q19 is not operating properly.
Is this a new build, or was it operating properly, then quit. That is 
good troubleshooting information.
If a new build, then it is possible that Q19 is not capable of 
oscillation at the proper frequency.
That is especially true if this is a kit tht has been "on the shelf" for 
some time.
There was a bad batch of FETs about 3 or 4 years ago, so if this is a 
build of an older kit, get a new Q19 from Elecraft support and you 
should be OK.
In any case, get a new Q19 and see if things then go smoothly.

73,
Don W3FPR

On 10/10/2026 12:11 PM, carlos popelier via Elecraft wrote:
> problem with k2 not receiving, 6v voltage not present or adjustable at r30
> first only 80m en 40m working,getting worse all bands stopped, on r 30
> voltage was + - 8v not adjustable, then 3,5v not adjustable, menus are
> working, no error messages, audio is working, any ideas where to start
> measuring.....
>
>
> mvg carlos popelier
> regards carlos popelier
>


More information about the Elecraft mailing list