[Elecraft] k2 vco voltage

Andrew Lenton a at lenton.org
Mon Oct 12 17:48:43 EDT 2026


Hi this is a tricky one! All I can suggest is start from scratch with the 
alignment, see if you get the 9-12:KHz bandwidth on the 12.096KHz Osc 
  
  
  
  
  Move on to PLL linearity. 
  
  
  
  
  Rewind the the T5, maybe the enamel wire and warn away? 
  
  
  
  
  
  
  
  KR 
  
  
  
  
  Andrew  
  
  
  
  
  
  
  
  
  
  
  


  
  
Hi Carlos, 
  
  
  
  
  
  
  
  
  
Thanks for additional detail about gradually failing VCO.  The fact that 
only one band, 20 meters, was initially affected, then others were 'lost', 
indicates a failure of the PLL to lock.  This can happen selectively, but 
its spread to more than one band indicates
  a systemic issue in the PLL circuits. 
  
  
  
  
  
  
  
  
  
What do you have for test equipment beyond a DMM?  A scope would help, and 
you may be able to use the K2 internal frequency counter to observe the VCO 
output in its unlocked state. 
  
  
  
  
  
  
  
  
  
To be clear, you said this K2 works if you swap the RF board and Control 
board from another K2? 
  
  
  
  
  
  
  
  
  
I believe the cause of the PLL failure to lock is on the RF board, not on 
the Control or Front Panel boards.  It is still too soon to pinpoint where 
in the PLL the cause is likely to be found. 
  
  
  
  
  
  
  
  
  
The occurrence of the INFO 080 message indicates a loss of AUXBUS 
communication with one or more of the chips on the bus.  Depending on where 
communication is lost, that could cause the PLL to fail to lock.  The MCU 
sends the synthesizer chip the necessary
  divider ratios for the selected carrier frequency. 
  
  
  
  
  
  
  
  
  
Without some test equipment beyond a DMM, it will be a challenge to find 
where the failure to lock is occurring. 
  
  
  
  
  
  
  
  
  
73, 
  
  
  
Mike, K8CN


More information about the Elecraft mailing list