[Elecraft] k2 vco voltage
Michael Carter
Mike.Carter at unh.edu
Mon Oct 12 14:53:07 EDT 2026
Hi Carlos,
Thanks for additional detail about gradually failing VCO. The fact that only one band, 20 meters, was initially affected, then others were 'lost', indicates a failure of the PLL to lock. This can happen selectively, but its spread to more than one band indicates a systemic issue in the PLL circuits.
What do you have for test equipment beyond a DMM? A scope would help, and you may be able to use the K2 internal frequency counter to observe the VCO output in its unlocked state.
To be clear, you said this K2 works if you swap the RF board and Control board from another K2?
I believe the cause of the PLL failure to lock is on the RF board, not on the Control or Front Panel boards. It is still too soon to pinpoint where in the PLL the cause is likely to be found.
The occurrence of the INFO 080 message indicates a loss of AUXBUS communication with one or more of the chips on the bus. Depending on where communication is lost, that could cause the PLL to fail to lock. The MCU sends the synthesizer chip the necessary divider ratios for the selected carrier frequency.
Without some test equipment beyond a DMM, it will be a challenge to find where the failure to lock is occurring.
73,
Mike, K8CN
More information about the Elecraft
mailing list