[Elecraft] k2 vco voltage

Andrew Lenton a at lenton.org
Mon Oct 12 07:36:36 EDT 2026


My post did not go through, 
  
  
  
  
  Is this a new build, failed in use or bought broken? 
  
  
  
  
  
  
  
  KR 
  
  
  
  
  Andrew 
  
  
  
  
  
  
  
  
  
  
  


  
  
Hi Carlos, 
  
  
  
  
  
  
  
  
  
When the voltage at R30 went to +8V, that indicates that the op amp U6B 
went to its positive rail.  U6B has no DC feedback path to stabilize its 
output at DC, and the output range center is biased to +4V by the fixed 
voltage at the non-inverting terminal (pin
  5 of U6).  Since U6B is configured as an inverting op amp, the railed 
output indicates that the phase detector output (pin 13, U4) was producing 
a lot of negative-going pulses, which when filtered by the RC lowpass 
filter gave rise to a low average (DC) voltage
  to the U6B inverting input.  The phase detector of the MC145170 supplies 
negative pulses when the frequency of the (divided) loop VCO is less than 
the frequency of the reference oscillator, i.e. the PLL is not locked. 
  
  
  
  
  
  
  
  
  
There can be many reasons for the loop failing to lock.  Once U6B goes to 
one of its rails, the VCO frequency is fixed at whatever value corresponds 
to the applied tuning voltage on the varactors (D23/D24/D25/D26) on the 
selected band.  L30 will have little
  or no effect if that frequency is too far removed from the lock range of 
the PLL. 
  
  
  
  
  
  
  
  
  
As Andrew asked, under what conditions did you first notice failure of the 
PLL/VFO system? 
  
  
  
  
  
  
  
  
  
73, 
  
  
  
Mike, K8CN


More information about the Elecraft mailing list