[Elecraft] k2 vco voltage

Michael Carter Mike.Carter at unh.edu
Sun Oct 11 20:30:56 EDT 2026


Hi Carlos,

When the voltage at R30 went to +8V, that indicates that the op amp U6B went to its positive rail.  U6B has no DC feedback path to stabilize its output at DC, and the output range center is biased to +4V by the fixed voltage at the non-inverting terminal (pin 5 of U6).  Since U6B is configured as an inverting op amp, the railed output indicates that the phase detector output (pin 13, U4) was producing a lot of negative-going pulses, which when filtered by the RC lowpass filter gave rise to a low average (DC) voltage to the U6B inverting input.  The phase detector of the MC145170 supplies negative pulses when the frequency of the (divided) loop VCO is less than the frequency of the reference oscillator, i.e. the PLL is not locked.

There can be many reasons for the loop failing to lock.  Once U6B goes to one of its rails, the VCO frequency is fixed at whatever value corresponds to the applied tuning voltage on the varactors (D23/D24/D25/D26) on the selected band.  L30 will have little or no effect if that frequency is too far removed from the lock range of the PLL.

As Andrew asked, under what conditions did you first notice failure of the PLL/VFO system?

73,
Mike, K8CN




More information about the Elecraft mailing list