[Elecraft] K2 Troubleshooting help

[Michael Carter]

Hi Sam,

You identified two issues with your recently acquired K2:  rig locked into transmit mode after using a straight key, and lack of response to MENU button presses.  It's not immediately apparent to me that these issues are connected causally, i.e. that the MENU button malfunction was caused by the event that caused the rig to lock up in transmit mode.

Had you been using a straight key for some time prior to the transmit lockup?  You mention alternating between straight key and paddle.  How do you have the KEY input wiring configured to share the KEY input between the straight key and the paddle?

As with all of the front panel buttons, the MENU button serves two functions: a short press opens the MENU options, a long press opens the EDIT function.  From your report, there are no MENU options visible on the display with a short press of that button?

The K2 control design strobes each of the buttons sequentially and looks for switch closure.  The MENU button is strobed upon activation of the /BANK1 signal (logic low) AND sampling of the D7 input to the parallel-to-serial converter.  D7 is also used for the XIT/PF2 button sensing when the
/BANK2 signal is asserted.  Please check that the XIT button is responsive to both short and long presses.  If so, that suggests that the MENU button has a mechanical failure or there may be a weak solder joint under it that has opened under repeated button presses.

I'll give some more thought to the transmit lockup issue later today.  I've not experienced that kind of lockup with my K2 except when there was excessive RF induced on the external wiring due to common-mode currents in the antenna connection.

73,
Mike, K8CN