[Elecraft] K3 sidetone level

[Chris]

I did update the firmware to 5.67b, but the sidetone level is still very
low compared to my 2nd K3.

I am still researching.  The support case with Elecraft didn't work
either.  They don't seem to understand the issue properly.

Thanks,

Chris KM1B


On Fri, Nov 15, 2024 at 2:59 PM Chris <ve3uvt at gmail.com> wrote:

> Thank you all for the replies.  I want to clarify the issue a little bit
> better.
>
> Both radios were tested with their internal and MFJ Cleartone speakers.  I
> have also tested them with a pair of Kenwood SP-230 speakers.  They all
> show equal results.  All tests were done with a single speaker, so no
> phasing issue here.
>
> One radio has the firmware 5.67, and the other has 5.2x.  I suspect it is
> the firmware issue, but I will report back here after testing them again on
> both radios with 5.67.
>
> Best regards,
>
> Chris KM1B
>
>
> On Fri, Nov 15, 2024 at 2:04 PM Jim Brown <jim at audiosystemsgroup.com>
> wrote:
>
>> On 11/15/2024 6:00 AM, Peter Lascell wrote:
>> > Try the AFX button on the K3, to change the audio phase.
>>
>> You clearly did not read my post.
>>
>> 73, Jim K9YC
>> ______________________________________________________________
>> Elecraft mailing list
>> Home: http://mailman.qth.net/mailman/listinfo/elecraft
>> Help: http://mailman.qth.net/mmfaq.htm
>> Post: mailto:Elecraft at mailman.qth.net
>>
>> This list hosted by: http://www.qsl.net
>> Please help support this email list: http://www.qsl.net/donate.html
>> Message delivered to ve3uvt at gmail.com
>>
>