[Elecraft] K3 Filters

[Brian Hunt]

There was a time when one could email Elecraft support with the K3 serial number and they would send the factory Config file. Probably not 100% of the solution but it would be a start. 

73,
Brian, K0DTJ 

> On Oct 17, 2023, at 09:05, W3FPR <w3fpr111 at gmail.com> wrote:
> 
> Jim,
> 
> It is doubtful that will work if the K3 has been set to factory defaults by EEINIT.
> 
> 73,
> Don W3FPR
> 
>> On 10/17/2023 11:59 AM, Jim McCook wrote:
>> Dave,
>> 
>> Open the K3 Utility and click on Calibration.  Scroll down to Configure Crystal Filters.  The top line shows the various bandwidths of the installed filters.  You can see the big picture there with the checked boxes.
>>      Jim W6YA
>> ______________________________________________________________
>> Elecraft mailing list
>> Home: http://mailman.qth.net/mailman/listinfo/elecraft
>> Help: http://mailman.qth.net/mmfaq.htm
>> Post: mailto:Elecraft at mailman.qth.net
>> 
>> This list hosted by: http://www.qsl.net
>> Please help support this email list: http://www.qsl.net/donate.html
>> Message delivered to w3fpr111 at gmail.com 
> 
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to huntinhmb at coastside.net