[Elecraft] K3s power level macro

[Robert Strickland]

Mike and Jack...

Thanks for your suggestions.
Mike, I'm not clear "where" you are implementing your macro; perhaps you 
are using the K3 utility. I'd like to avoid that and interact with the 
radio directly. Jack, what I'm looking for is not different drive levels 
on different bands, but switching drive levels on the same band 
"instantaneously." For example, I'm chasing DX and not getting through 
at 100w; turn on the amp, hit the macro button, and transmit; no 
adjustment. You might have noticed that the power level knob changes the 
K3s power out very slowly, and I'm trying to get around that with a 
macro. Thanks much. Looking forward to your replies.

...robert    KE2WY

On 12/5/2023 18:35, Robert Strickland via Elecraft wrote:
> Is there a way to program a macro within the K3s to set power
> level(s)? My goal is to be able to shift between low power barefoot
> [100w] and a drive level for the KPA500 [15-20w]. Thanks
> 
> ..robert   KE2WY

-- 
Robert G. Strickland, PhD ABPH KE2WY
rcrgs at verizon.net
Syracuse, New York FN13xa