[Elecraft] Elecraft K4 Vs. Flex 6400

[Ian Kahn]

Kurt,

A good starting point would be Rob Sherwood's receiver analysis. It can be
found at:

http://www.sherweng.com/table.html

I'm not sure/aware of anyone who performed direct transmitter comparisons.

73 de,

Ian, NV4C

On Sat, Mar 5, 2022 at 1:19 AM Kurt Pawlikowski <kurtt at pinrod.com> wrote:

> Hi!
>
>      I was wondering whether there is anyone who has done a side-by-side
> comparison between the K4 and the Flex 6400 or any other Flex "direct to
> digital" radio?
>
>      Background: As it happens, I purchased a 6400, which I received
> about 9 months ago. I use it with a computer, but I had ordered a
> Maestro when I ordered the 6400. Unfortunately, the Maestro is still on
> back-order and will be until some time next year. When I checked with
> Elecraft, they said the delay time for a K4 was about 6 months (no, I
> won't hold them to that!). So, I'm wondering if it would be worth
> jumping to the K4. Mind you, I'm not unhappy with the Flex and, when I
> ordered it I had considered a K4, but it was outside my budget at that
> time. I'm rethinking that decision. Also, I've been an Elecraft fan for
> quite some time. At any rate, I'd like some opinions from experience and
> the only ones I have seen were written before the K4 was available. So,
> a little help would be appreciated! Thanks!
>
>      k WB9FMC
>
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to nv4c.ian at gmail.com



-- 
Ian Kahn, NV4C
Roswell, GA  EM74ua
nv4c.ian at gmail.com
10-10 #74624  North Georgia Chapter #2038
PODXS 070 #1962
K3 #281, P3 #688 KAT500 #860, KPA500 #1468