[Elecraft] KX3 and Heatsink

[Eric Garner]

When you say " Elecraft-supplied heat sink" do you just mean the
little heat spreader plate?

The factory provided thermal solution is totally fine unless you want to
run high duty cycle modes at full power. I have the proaudio ultimate (
https://proaudioeng.com/pae-kx32-ultimate-heatsink-kit-elecraft-kx3/) on
mine and have no complaints.

Eric KI7LTT


On Mon, Jun 13, 2022 at 1:54 PM Bill Lederer <w8lvn.9 at gmail.com> wrote:

> Folks:
>
> I have a recently-purchased KX3 that includes the Elecraft-supplied heat
> sink.
>
> Is there any opinion of this does an adequate job compared to the ProAudio
> one?
>
> Thanks,
> --
> --w8lvn--
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to garnere at gmail.com
>


-- 
--Eric
_________________________________________
Eric Garner