[Elecraft] KPA500 on 10Meters

[Larry Christensen]

The station is working as it should. I checked all the ideas. Still no joy. 
Turned it off and went to supper. I came back and turned everything on it worked as it should. 
Maybe just needed a reboot.  
Thank everyone for your ideas. 

Larry NA0F

Sent from my iPhone

> On Jan 25, 2022, at 4:23 PM, NCElarry at scicable.com wrote:
> 
> 
> I have a K3,KAT500 and KPA500. I had a station on 10 Meters this afternoon that I wanted to reach.
> 
> The KPA500 did not work on 10M as if it was in standby mode (it was not), the KAT500 tuner didn't  tune either the K3 showed 1.0-1 5W all across the 10m band but no relays clicks in the KAT500. I tested after this happened and both work as expected on all other bands. It has been years since I used 10M.  The firmware is current on all three units. 
> 
> Any thoughts or ideas.
> 
> TIA 
> 
> Larry NA0F
> 
>