[Elecraft] KPA500 on 10Meters

[G4GNX]

I can’t remember where or exactly what the settings are, but between the 3 pieces in use, it’s possible to set the KPA500 to stay in standby, per band. It was a long time back, but I remember setting mine so that I could not TX hight power on 6 metres, due to the antenna not being rated above 100W.

I hope that gives you some clues.

73,
Alan - G4GNX



> On 25 Jan 2022, at 22:21, ncelarry at scicable.com wrote:
> 
> 
> 
> I have a K3,KAT500 and KPA500. I had a station on 10 Meters this afternoon that I wanted to reach.
> 
> The KPA500 did not work on 10M as if it was in standby mode (it was not), the KAT500 tuner didn't  tune either the K3 showed 1.0-1 5W all across the 10m band but no relays clicks in the KAT500. I tested after this happened and both work as expected on all other bands. It has been years since I used 10M.  The firmware is current on all three units.
> 
> Any thoughts or ideas.
> 
> TIA
> 
> Larry NA0F
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to g4gnx at g4gnx.com