[Elecraft] K3 drive level for Q5 Signal 432 Transverter

[Gary Johnson]

Sounds like you should do the low-level power calibration using the K3 Utility. For now, you can increase the maximum, up to 1.5 mW, and presumably get the desired output.

Gary NA6O  

> Using the Config Menu, I have set the drive level at the maximum for the transverter at 1 MW.  However, when I check the drive from the front panel PWR knob it reads 0.8MW and I cannot adjust it any higher with the knob.  Nothing I do seems to change the the PWR knob drive level.  I am running SSB on 432.095.
> 
> Any suggestions would be most appreciated.
> 
> Tnx es 73,
> 
> NS4V