[Elecraft] K4 to KPA500?

[Dave]

Bob

There has been a thread on the K4 groups.io on this subject. There is much
more info concerning the K4 on there. While mine works correctly, some
don’t. I think a pin needs cutting off, you might check with a breakout box.

73 Dave G4AON

On Tue, 22 Feb 2022 at 14:53, Robert Sands <k7voradio at gmail.com> wrote:

> My old cable, used with K3 and KPA500 works fine with K4 to KPA 1500
> except the K4 receive is shut down when 1500 in off, regardless of cable or
> use of interruptor. Ideas?
>
> Happens Only on 40 and 75, not 20. No receive until 1500 is on. I also
> tried the new cable.
> Bob
> K7VO
>
> On Tue, Feb 22, 2022, 5:27 AM Dave <dave.g4aon at gmail.com> wrote:
>
>> No difference between using the K3 and K4. I use the same interconnection
>> cable that I used for the K3.
>>
>> The K4 shows the power level against the power control knob as appropriate
>> when you go from standby to operate.
>>
>> Power setting/control with the K4 and KPA500 is well controlled.
>>
>> 73 Dave
>> K4D #286
>> KPA500
>
>
>> --
>> Sent from my iPhone SE
>> ______________________________________________________________
>> Elecraft mailing list
>> Home: http://mailman.qth.net/mailman/listinfo/elecraft
>> Help: http://mailman.qth.net/mmfaq.htm
>> Post: mailto:Elecraft at mailman.qth.net
>>
>> This list hosted by: http://www.qsl.net
>> Please help support this email list: http://www.qsl.net/donate.html
>> Message delivered to k7voradio at gmail.com
>>
> --
Sent from my iPhone SE