[Elecraft] Need K3 Board

[Ed Cole]

My KI03 board failed in 2020 and I was lucky to get it repaired by 
Elecraft (though it took months due to Covus issues).

I blew up a ferrite cube and IC so decided to have them do the repair 
since the IC leads were high density and I didn't trust being able to 
desolder without damage to the board.  Highly suspect board is multi-layer.

Without use of the KI03 board my K3 would be useless.  Hope it doesn't 
fail again.  Cause?? as we get no lightening locally.

73, Ed - KL7UW
K3-10 sn 4340 bought in 2010


From: David Gilbert <ab7echo at gmail.com>
To: Ray <wa6vab at gmail.com>,	"elecraft at mailman.qth.net"
	<elecraft at mailman.qth.net>
Subject: Re: [Elecraft] Need K3 Board
Message-ID: <7a88a321-850b-18d7-1c32-fb0f27907ec5 at gmail.com>
Content-Type: text/plain; charset=UTF-8; format=flowed


LOL.? I bet you don't even know if the board is multilayer or not. I
don't, and I'm not about to pull it out of the rig just to find out.

I had a KIO3 board go bad in the past and was lucky enough to be able to
replace it then.? Pretty certain I'm screwed if it happens again.

Dave?? AB7E