[Elecraft] Frequency shifts of KX3 when selecting CW?

[Paul Jewell]

I have this behaviour on my Yaesu Ft-897. If I set the CW modulation to 
700 kHz, then it will move to 1.700 MHz. I thought this was "normal" 
behaviour, and I was afraid to ask about it (relatively new ham). I 
haven't tried to do the same on my KX3, but I will get it out and try it.

I don't think this is due to dropping it - I think it is intentional to 
give you the correct tone for CW.

Rgds.,
Paul

On 26/07/2021 19:05, Tom wrote:
> Hi
> I don't recall this happening before, but if I am tuned to a signal lets say
> at 1.000 MHz in AM and then I switch to CW, the frequency display on the
> radio changes to 1.600 MHz.
> My K3 and KX2 do not do this.  Is there a setting somewhere?
> I did drop my KX3 at one point recently so I am wondering if a button or
> worse was pressed.
> Thanks, Tom
>
>