[Elecraft] Frequency shifts of KX3 when selecting CW?

[Don Wilhelm]

Tom,

As an experiment, try tuning the KX3 to a valid ham band like 160 meters 
in AM mode, then switch to CW.
What happens?

1.000 MHz is in the middle of the AM broadcast band, so that is not a 
good example.  I am thinking perhaps this is built into the KX3 firmware 
to prevent transmitting CW on the AM broadcast band - but that is just a 
guess.

73,
Don W3FPR

On 7/26/2021 2:05 PM, Tom wrote:
> Hi
> I don't recall this happening before, but if I am tuned to a signal lets say
> at 1.000 MHz in AM and then I switch to CW, the frequency display on the
> radio changes to 1.600 MHz.
> My K3 and KX2 do not do this.  Is there a setting somewhere?
> I did drop my KX3 at one point recently so I am wondering if a button or
> worse was pressed.
> Thanks, Tom
>
>