[Elecraft] K3 on wsjt-x

[Don Wilhelm]

Doug,

You have had suggestions on this reflector on how to get in DATA A mode.
As far as audio levels are concerned, I have an article on my website 
www.w3fpr.com that may be helpful.
Scroll the left column to the last entry and click to open the document.

Bottom line is that you must have 4 bars solid on the ALC meter with the 
5th bar flashing.  You may have up to 3 audio level controls to work 
with.  It is best to start with them all set to mid-range, then adjust 
from there.

73,
Don W3FPR

On 7/3/2021 5:35 PM, doug dietz wrote:
> Guys
> I have k3 with all the options available except finals. I have installed the ftdi driver. The receiver sends frequency and decodes wsjt signals correctly.   In the wsjt program the cat test turns green and the ptt  works ok. When I call cq the transmitter is keyed but no power is sent out. I think I’m in the wrong mode. Any  suggestions. I cannot get it to “data a”?  HELP
> WD8Z. Doug
>