[Elecraft] [DXLab] Powering down K3 using DXLab Commander

[David F. Reed]

Thanks Ian, that did it!

73 de Dave, W5SV

On 2/12/2021 19:57, iain macdonnell - N6ML wrote:
> On Fri, Feb 12, 2021 at 11:46 AM David Reed <w5sv.dave at gmail.com> wrote:
>> I need some help figuring this out; I can do the power down from the Elecraft Utility (using command "PS0;")
>>
>> In trying to get it to run from Commander, I have done the following (but no results); other than this, Commander is working fine.
>>
>> User -defined Command Sequence:
>>      Note:             Power Off
>>      Command:    PS0;
> Try the following:
>
> 'PS0;
>
> ASCII commands must be prefixed with a single-quote - see
> https://www.dxlabsuite.com/commander/Help/CommandSequences.htm
>
> 73,
>
>      ~iain / N6ML
>
>
> -=-=-=-=-=-=-=-=-=-=-=-
> Groups.io Links: You receive all messages sent to this group.
> View/Reply Online (#199690): https://groups.io/g/DXLab/message/199690
> Mute This Topic: https://groups.io/mt/80592472/361262
> Group Owner: DXLab+owner at groups.io
> Unsubscribe: https://groups.io/g/DXLab/leave/2013996/937810539/xyzzy [w5sv.dave at gmail.com]
> -=-=-=-=-=-=-=-=-=-=-=-
>
>