[Elecraft] [DXLab] Powering down K3 using DXLab Commander

[iain macdonnell - N6ML]

On Fri, Feb 12, 2021 at 11:46 AM David Reed <w5sv.dave at gmail.com> wrote:
>
> I need some help figuring this out; I can do the power down from the Elecraft Utility (using command "PS0;")
>
> In trying to get it to run from Commander, I have done the following (but no results); other than this, Commander is working fine.
>
> User -defined Command Sequence:
>     Note:             Power Off
>     Command:    PS0;

Try the following:

'PS0;

ASCII commands must be prefixed with a single-quote - see
https://www.dxlabsuite.com/commander/Help/CommandSequences.htm

73,

    ~iain / N6ML