[Elecraft] Need a tuning knob for K2

[Frank Krozel]

Thanks Don, will check today.

I also need to figure out which K2 need those small 3/8”x3/8” rubber spacers in-between the PC boards without taking the front panel off.

-73-  Frank    KG9H
kg9hfrank at gmail.com




> On Apr 25, 2021, at 9:27 AM, Don Wilhelm <don at w3fpr.com> wrote:
> 
> Frank,
> 
> Do you have the new encoder?  I don't know which SN they were started.  That is the key to which knob you need.  If the knob is off, lift the fiber washers and check to see if there is a green tab in the hole to the right of the encoder shaft.  If the hole is empty, you have the new encoder.
> Order the new knob from Elecraft - they no longer have the older knob.
> With the new knob, you need 3 fiber washers stacked.
> 
> 73,
> Don W3FPR
> 
> On 4/25/2021 9:00 AM, Frank Krozel wrote:
>> I am looking for a tuning knob for a K2 SN 5630
>> If I recall there were two different sizes of shafts, this would be the second (maybe current) size.
>> 
>> This is SN
>> -73-  Frank    KG9H
>> kg9hfrank at gmail.com
>> 
>> 
>> 
>> 
>> ______________________________________________________________
>> Elecraft mailing list
>> Home: http://mailman.qth.net/mailman/listinfo/elecraft
>> Help: http://mailman.qth.net/mmfaq.htm
>> Post: mailto:Elecraft at mailman.qth.net
>> 
>> This list hosted by: http://www.qsl.net
>> Please help support this email list: http://www.qsl.net/donate.html
>> Message delivered to don at w3fpr.com
>