[Elecraft] KAT500 remote

[Gordon LaPoint]

Andy,
    Thanks, but I'm trying to use KAT500-Remote Version 1.0.15.0 from 
the Elecraft Web site, under "Logging, Control and Remote Software for 
K-Line & KX-Line". This  allows for hosting a KAT500 over the internet 
for control by multiple clients.  The actual commands sent to the tuner 
are hidden by the software.
Thanks,
Gordon - N1MGO

On 10/10/2020 8:47 AM, Andy Durbin wrote:
> "Someone on another group mentioned sending P; to the KPA500 would turn the amp on provided to main power switch was on. Can you confirm that?"
>
> The power on command is P  not P;
>
>  From the programmer's reference -
>
> "BootLoader Command Reference
> The KPA500 uses single character commands when in boot mode. Boot mode is the state the KPA500 is
> in when the rear panel power switch is in the ON position, while the main firmware is not running. This
> mode is used for starting up the KPA500 or downloading fresh firmware. Bootloader commands must be
> sent upper-case only.
>
> P Power On
> The P command will cause the KPA500 to perform internal firmware checks, then execute the main
> firmware to power up the amplifier. This is the command to use to remotely power up the KPA500. No
> response is sent from the KPA500 after receiving this command."
>
> Andy, k3wyc
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to gordon.lapoint at gmail.com