[Elecraft] KAT500 remote

[Gordon LaPoint]

Andy,
     Thanks, but I'm not using software I wrote.  I'm using the remote 
software from Elecraft, and that is the software I'm talking about not 
seeing if the power is on or off.   I was hoping that I was just missing 
seeing something.
Gordon - N1MGO

On 10/9/2020 20:56 PM, Andy Durbin wrote:
> Sorry - cut/paste error - should be:
>
> If a KAT500 is powered but off it will respond to command ps; with PS0;
> If a KAT500 is powered and on it will respond to command ps; with PS1;
> If a KAT500 is not powered it will not respond to ps;
>
> Andy, k3wyc
> ________________________________
> From: Andy Durbin
> Sent: Friday, October 9, 2020 5:51 PM
> To: elecraft at mailman.qth.net <elecraft at mailman.qth.net>
> Subject: KAT500 remote
>
> "I use the KAT500 remote software and it works great. I have only one problem with it, I can not tell if the power is on or off."
>
> If a KAT500 is powered but off it will respond to command ps; with PS0;
> If a KAT500 is powered and on it will respond to command ps; with PS1;
> If a KAT500 is not powered it will not on it will not respond to ps;
>
> Powered status can also be found by checking the response to ;
> No response if not powered
> ; response if powered.
>
> Hopefully any remote control software you use will be smart enough to apply these tests and indicate the result.
>
> Andy, k3wyc
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to gordon.lapoint at gmail.com