[Elecraft] KAT500 remote

[Dave]

Hi Andy,

Someone on anothergroup mentioned sending P; to the KPA500 would turn the amp on provided to main power switch was on. Can you confirm that?

Reason is I want to make sure the Node Red flow I had mentioned is programmed correctly.

I use Wake on Lan with the KPA1500 successfully.

Thanks
Dave wo2x

Sent from my iPad

> On Oct 9, 2020, at 8:58 PM, Andy Durbin <a.durbin at msn.com> wrote:
> 
> Sorry - cut/paste error - should be:
> 
> If a KAT500 is powered but off it will respond to command ps; with PS0;
> If a KAT500 is powered and on it will respond to command ps; with PS1;
> If a KAT500 is not powered it will not respond to ps;
> 
> Andy, k3wyc
> ________________________________
> From: Andy Durbin
> Sent: Friday, October 9, 2020 5:51 PM
> To: elecraft at mailman.qth.net <elecraft at mailman.qth.net>
> Subject: KAT500 remote
> 
> "I use the KAT500 remote software and it works great. I have only one problem with it, I can not tell if the power is on or off."
> 
> If a KAT500 is powered but off it will respond to command ps; with PS0;
> If a KAT500 is powered and on it will respond to command ps; with PS1;
> If a KAT500 is not powered it will not on it will not respond to ps;
> 
> Powered status can also be found by checking the response to ;
> No response if not powered
> ; response if powered.
> 
> Hopefully any remote control software you use will be smart enough to apply these tests and indicate the result.
> 
> Andy, k3wyc
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to rocketnj at gmail.com