[Elecraft] KAT500 remote

[Andy Durbin]

Sorry - cut/paste error - should be:

If a KAT500 is powered but off it will respond to command ps; with PS0;
If a KAT500 is powered and on it will respond to command ps; with PS1;
If a KAT500 is not powered it will not respond to ps;

Andy, k3wyc
________________________________
From: Andy Durbin
Sent: Friday, October 9, 2020 5:51 PM
To: elecraft at mailman.qth.net <elecraft at mailman.qth.net>
Subject: KAT500 remote

"I use the KAT500 remote software and it works great. I have only one problem with it, I can not tell if the power is on or off."

If a KAT500 is powered but off it will respond to command ps; with PS0;
If a KAT500 is powered and on it will respond to command ps; with PS1;
If a KAT500 is not powered it will not on it will not respond to ps;

Powered status can also be found by checking the response to ;
No response if not powered
; response if powered.

Hopefully any remote control software you use will be smart enough to apply these tests and indicate the result.

Andy, k3wyc