[Elecraft] K3S RX OUT

[Jim Brown]

While the K3 RX input does provide a well matched 50 ohm load to the 
antenna (and BPF), I've never found the need to use a splitter.

73, Jim K9YC

On 11/14/2020 11:33 AM, Joe Subich, W4TV wrote:
> 
> Yes, RX out is after the K3/K3S TR Switch and LPF.  You will need to
> turn on the RX ANT function.  RX Out should be connected to to a
> splitter with one output of the splitter going to the RSP1A (or other
> SDR) and the other output of the splitter going to the RX IN.
> 
> A properly designed splitter prevents either receiver from "loading"
> the other (excessive signal reduction) as well as preventing any
> spurious products from one receiver being fed into the other.
> 
> 
> 73,
> 
>     ... Joe, W4TV
> 
> 
> On 2020-11-14 11:31 AM, Jim McDonald wrote:
>> Can an SDR, such as a SDRPlay RSP1A, be connected to the RX OUT jack 
>> on the K3S instead of using the IF OUT (on the radio or the P3)?
>>
>> 73,  Jim N7US
>>
> 
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to jim at audiosystemsgroup.com