[Elecraft] K3 shift-width/lo-hi

[Martin Sole]

Keith,

Many thanks for the heads up. I did the gain calibration instinctively 
as I did not know if it would be modified by the EE-Init or not, the D10 
manual page 66 on parameter initialization does not state.

All working well now and the radio is back to proper operation.

Martin, HS0ZED


On 31/03/2020 04:50, Keith Trinity WE6R wrote:
> Don't forget to do the TX gain cal, that gets wiped during EE INIT.
> Then save the config.
> **BUT; You might try loading your saved config, then read my notes;
> From my notes;
>
> *_Cannot toggle LEDs SHIFT LO CUT HI WIDTH TAPPING LOCKED in CW or 
> DATA mode(s) + N/A_*
>
> _Fix;_Turn off “CW QRQ” in config menu, or set “PB CTRL” to .05 
> instead of .01
>
> Notes; Any of the following, in any combination, will lock out the 
> toggle to HI CUT / LO CUT:
>
> CW mode and CW QRQ ON ("+" sign visible on LCD display, not flashing)
>
> CW mode and CONFIG:PB CTRL Shift=.01
>
> DATA mode (FSK/AFSK)
>
> Keith WE6R