[Elecraft] K3 shift-width/lo-hi

[Buck]

How about this one?  K3S CW mode. Tone at 14.053.953 with shift at 650 
Hz, lox cut at .10  High cut at 1.20.  Same tone at 7.026.765 and 
21.074.113 but weaker.  The tone is strong enough to show a spike on the 
P3.

Tone goes away if I move the shift off 650 Hz or change the low cut or 
high cut.  But the spike still appears on the P3 screen?  Something in 
the P3?

k4ia, Buck
K3s# 11497
Honor Roll  8B DXCC
EasyWayHamBooks.com

On 3/30/2020 5:50 PM, Keith Trinity WE6R wrote:
> Don't forget to do the TX gain cal, that gets wiped during EE INIT.
> Then save the config.
> **BUT; You might try loading your saved config, then read my notes;
>  From my notes;
> 
> *_Cannot toggle LEDs SHIFT LO CUT HI WIDTH TAPPING LOCKED in CW or DATA 
> mode(s) + N/A_*
> 
> _Fix;_Turn off “CW QRQ” in config menu, or set “PB CTRL” to .05 instead 
> of .01
> 
> Notes; Any of the following, in any combination, will lock out the 
> toggle to HI CUT / LO CUT:
> 
> CW mode and CW QRQ ON ("+" sign visible on LCD display, not flashing)
> 
> CW mode and CONFIG:PB CTRL Shift=.01
> 
> DATA mode (FSK/AFSK)
> 
> Keith WE6R
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to radiok4ia at gmail.com