[Elecraft] [K3] RTTY Setup

[Joe Subich, W4TV]

1) Are you changing bands on the rig or by using N1MM+?

   a) If "rig" - Data Mode is stored by band.  Change it on each band.
   b) If "N1MM+" - be sure to set "Digital Modes" to AFSK

> Second, the K3 is staying in Transmit after the RTTY message is 
> finished. I usually have to press the XMIT button to return to
> receive.
Assuming this is with N1MM+ - set the rig port to allow Command PTT for
digital and make sure all your messages end with the command to return
to receive (%E or %R - I'm not sure and not in front of N1MM).

73,

    ... Joe, W4TV


On 2020-06-19 12:04 PM, John Reilly wrote:
> I've recently changed from FSK to AFSK, and having issues. FWIW, I am 
> using N1MM with 2Tone as my RTTY interface, with the K3 internal sound 
> card.
> 
> First, When I go to DATA MD, it is always set to FSK D. I reset it to 
> AFSK A and it works; however, if I change bands, it resets itself to FSK 
> D. The AFSK A setting does not "stick" - is there a way to make the K3 
> remember this setting?
> 
> Second, the K3 is staying in Transmit after the RTTY message is 
> finished. I usually have to press the XMIT button to return to receive. 
> I do not have anything setup in the 2Tone PTT box, which I suspect is 
> the problem. I tried to use the serial DTR, but 2Tone was unable to use 
> the serial port that N1MM was using. I also tried VOX, but did not see a 
> difference. Any suggestions for setting up AFSK PTT?
> 
> Thanks,
>    - 73, John, N0TA